patterns > Buttercup Miniatures and 1 more...
> 1:12th scale chair backs
1:12th scale chair backs
This pattern is now available with a choice of either UK or US crochet terms
Materials required: Materials required for all items: 0.60 mm (US size 14) crochet hook, small amount (1/8th ball approximately) of No 100 crochet cotton or good quality sewing thread.
NOTE: The set can also be worked using No 80 crochet cotton or Tatting thread No 70 (allow 1 x 5g ball for the complete set), but this will slightly increase the size of all items. If you do wish to use this thicker yarn, make a trial chain first to check size variations.
Finished sizes (approx.):
Chairback – 1½-inches/4 cm across by 2-inches/5 cm long
Traycloth – 1-inch/2.5 cm across by 1½-inches/4 cm long
Chair arm covers - ½-inch/1.25 cm across ends, ¾-inch/2 cm deep
Gauge: 6 tr = ⅜-inch/1 cm across
BEFORE PURCHASING PATTERN PLEASE NOTE:
Cancellation of digital goods Under the UK provisions of Consumer Contracts (Information, Cancellation and Additional Charges) Regulations 2013 the following conditions will apply: By clicking the download button(s) on the Ravelry download page you expressly request that the digital content is immediately available for download (this may be within the 14 days statutory cancellation period) and you agree to waive your right to cancel and refund once the download(s) has started.
Full terms and conditions can be found here.
Copyright Notice All rights reserved. All patterns are for private use only and may not be reproduced in any form, or reproduced for commercial gain including selling any item knitted up from these patterns without written permission from Buttercup Miniatures. Reproducing or transmitting these patterns by any means for any purpose other than for personal use constitutes a violation of UK copyright law.
- First published: May 2004
- Page created: October 22, 2010
- Last updated: October 23, 2018 …
- visits in the last 24 hours
- visitors right now