Crochet pattern to make a 1/12th scale Posy Holder for a Bride or Bridesmaid with Flowers & Buttonhole for Bridegroom for a dolls house wedding

Materials required:
Posy holder: 0.40 mm crochet hook, small amount No. 100 crochet cotton.
Flowers: 0.60 mm crochet hook, small lengths of No 80 crochet cotton or No 70 tatting thread for flowers, thin green wire, tacky glue. For starching, see below. (NOTE: a larger hook and thread can be used, but the finished posy holder will be much larger than that shown), thin ribbon-optional.

For Experienced crochet workers. Gauge is not important for ths project

BEFORE PURCHASING PATTERN PLEASE NOTE:

Cancellation of digital goods Under the UK provisions of Consumer Contracts (Information, Cancellation and Additional Charges) Regulations 2013 the following conditions will apply: By clicking the download button(s) on the Ravelry download page you expressly request that the digital content is immediately available for download (this may be within the 14 days statutory cancellation period) and you agree to waive your right to cancel and refund once the download(s) has started.

Full terms and conditions can be found here.

Copyright Notice All rights reserved. All patterns are for private use only and may not be reproduced in any form, or reproduced for commercial gain including selling any item knitted up from these patterns without written permission from Buttercup Miniatures. Reproducing or transmitting these patterns by any means for any purpose other than for personal use constitutes a violation of UK copyright law.