To fit a 32.5 cm/13-inch tall doll (including broad Ken)

Ability Level: Intermediate
This has been classed as intermediate ability due to the tiny needles used. The actual jumper is fairly simple to knit

Materials required
One pair of size 1.50 mm knitting needles (use 2.00 mm needles for Broad Ken or heavier built doll bodies); 60-80 metres/65-87 yards No.10 or No.12 crochet cotton; 3 small buttons or beads, 5 stitch holders or safety pins.

Approximate finished size:
Using 1.50 mm needles
Neck to hem - 9.25 cm/3½-inches; Sleeve seam – 2.5 cm/1-inch; Width across chest – 7 cm/2¾-inches.
Using 2.00 mm needles
Neck to hem - 8 cm/3-inches; Sleeve seam – 8 cm/3-inches; Width across chest - 7.5 cm/3-inches.

Gauge
Using 1.50 mm needles -18 rows and 12 stitches = 2.5 cm/1-inch over stocking stockinette stitch
Using 2.00 mm needles -16 rows and 11 stitches = 2.5 cm/1-inch over stocking stockinette stitch

BEFORE PURCHASING PATTERNS PLEASE NOTE:

Cancellation of digital goods Under the UK provisions of Consumer Contracts (Information, Cancellation and Additional Charges) Regulations 2013 the following conditions will apply: By clicking the download button(s) on the Ravelry download page you expressly request that the digital content is immediately available for download (this may be within the 14 days statutory cancellation period) and you agree to waive your right to cancel and refund once the download(s) has started.

Full terms and conditions can be found here.

Copyright Notice All rights reserved. All patterns are for private use only and may not be reproduced in any form, or reproduced for commercial gain including selling any item knitted up from these patterns without written permission from Buttercup Miniatures. Reproducing or transmitting these patterns by any means for any purpose other than for personal use constitutes a violation of UK copyright law.