To fit a 29-30 cm/11-½ to 12-inch tall doll (including Curvy Barbie)

Materials required for either jumper:
Size 1.50 mm knitting needles, 150 yards/ metres No 10 crochet cotton or 2-ply yarn, 2 stitch holders or safety pins plus cable needle for cable lattice sleeves.

Approximate finished size:
Waist to ankle - 6½-inches/16 cm, 3½-inches/8.5 cm wide at waist, sleeve length – lattice sleeves - 3¼-inches/8 cm; plain sleeves 3¾-inches/10 cm

Ability Level - Intermediate to Experienced
NOTE: Even if you are a very experienced knitter, the cable lattice sleeves are NOT suitable for a first project in miniature knitting.
,
Gauge – worked over stocking stitch: 7 rows and 6 sts = 1 cm

BEFORE PURCHASING PATTERNS PLEASE NOTE:

Cancellation of digital goods Under the UK provisions of Consumer Contracts (Information, Cancellation and Additional Charges) Regulations 2013 the following conditions will apply: By clicking the download button(s) on the Ravelry download page you expressly request that the digital content is immediately available for download (this may be within the 14 days statutory cancellation period) and you agree to waive your right to cancel and refund once the download(s) has started.

Full terms and conditions can be found here.

Copyright Notice All rights reserved. All patterns are for private use only and may not be reproduced in any form, or reproduced for commercial gain including selling any item knitted up from these patterns without written permission from Buttercup Miniatures. Reproducing or transmitting these patterns by any means for any purpose other than for personal use constitutes a violation of UK copyright law.