To fit a 25-27 cm/10 to11-inch tall doll (such as Skipper or Harry Potter dolls)

Note: The sleeves, body and neck of the jumper are designed so they may be worked in any combination. The patterns are written to show how to knit each style shown in the photo. The jumpers fit both male and female dolls.

Ability Level: Intermediate

Materials required:
one pair 2.00 mm knitting needles; between 40 to 55 metres 4-ply/fingering cotton yarn for each jumper (depending on combination worked), 3 stitch holders

Approximate finished sizes
Across chest: 5 cm/2-inches
Neck to hem: 6.5 cm/2½-inches to 7.5 cm/3-inches
Sleeve seams: long - 7 cm/2¾-inches; short - 1 cm/¼-inch; elbow length - 3 cm/1½-inches

Gauge
Worked over stocking stitch: 5 rows = 1 cm and 4 stitches = 1 cm

BEFORE PURCHASING PATTERNS PLEASE NOTE:

Cancellation of digital goods Under the UK provisions of Consumer Contracts (Information, Cancellation and Additional Charges) Regulations 2013 the following conditions will apply: By clicking the download button(s) on the Ravelry download page you expressly request that the digital content is immediately available for download (this may be within the 14 days statutory cancellation period) and you agree to waive your right to cancel and refund once the download(s) has started.

Full terms and conditions can be found here.

Copyright Notice All rights reserved. All patterns are for private use only and may not be reproduced in any form, or reproduced for commercial gain including selling any item knitted up from these patterns without written permission from Buttercup Miniatures. Reproducing or transmitting these patterns by any means for any purpose other than for personal use constitutes a violation of UK copyright law.