patterns >
Physicsknits
> Austin Hoodie
![](https://images4-f.ravelrycache.com/flickr/4/5/7/4571071297/4571071297_t.jpg)
Austin Hoodie
Tip 1: If you find yourself with holes where you pick up the sts again for the hood, I suggest using a trick I use for filling in holes for mittens/gloves -- pick up a few extra sts in those areas and then decrease the sts down again to the specified number in the pattern as soon as you can (usually by the next row).
Tip 2:To minimize holey-ness where you pick up stitches around the armcycle for the sleeve cap, knit through the back loop the first time you knit the picked up stitches. That will tighten up the sts and after that first knit, you can resume normal knitting through the front.
ERRATA: (Revised 11/14/11)
The last paragraph on page 5 should read: ”…Work to marker, m1, sm, work 0 (0, 0, 0, 1, 0) sts, sm, m1, work to end.” The increases should always be where the center of the hood is (around the two markers used to mark the hood center) to make it easier to incorporate the ribbing pattern into the increased stitches. There should be 2 increases per increase round.
More information on the design can be found here.
Yarn note: Many people have asked, so I thought I would answer on the pattern page. As far as I know, Tosh Merino Light is not available widely yet. Amy included it in her yarn club and it’s available on her etsy site:
http://www.etsy.com/shop/madelinetosh
She is planning on debuting it officially at TNNA in June; after which the yarn should be available in local yarn shops.
Thanks for the interest in the pattern! The yarn really is very lovely and makes the design in my opinion.
131011 projects
stashed
145472 times
- First published: May 2010
- Page created: May 2, 2010
- Last updated: October 17, 2022 …
- visits in the last 24 hours
- visitors right now