Ability level: Experienced

This cushion uses a mix of intarsia and stranded colourwork. The front of the cushion is charted with only minimal instructions for setting up the colourwork, the back of the cushion has written instructions.

The second in a series of London skylines cushions.

Materials required for cushion: size 3 mm knitting needles, 150g/450 metres DK weight yarn in main colour, 50g/140 metres contrast colour DK weight yarn, (optional - 2 metres pale yellow or cream for clock dial), 3 x 2 cm buttons for cushion back, tapestry needle, 40 cm square cushion pad.
NOTE: The cushion works best if strongly contrasting colours are used.

Finished size: approximately 16-inches/40 cm square

Gauge: 2.5 cm/1-inch = 5 rows and 6 sts over colour pattern

This would also work well as a a wall hanging, if the front panel of the cushion was mounted over card or a wooden board.

BEFORE PURCHASING PATTERNS PLEASE NOTE:

Cancellation of digital goods Under the UK provisions of Consumer Contracts (Information, Cancellation and Additional Charges) Regulations 2013 the following conditions will apply: By clicking the download button(s) on the Ravelry download page you expressly request that the digital content is immediately available for download (this may be within the 14 days statutory cancellation period) and you agree to waive your right to cancel and refund once the download(s) has started.

Full terms and conditions can be found here.

Copyright Notice All rights reserved. All patterns are for private use only and may not be reproduced in any form, or reproduced for commercial gain including selling any item knitted up from these patterns without written permission from Buttercup Miniatures. Reproducing or transmitting these patterns by any means for any purpose other than for personal use constitutes a violation of UK copyright law.