patterns > Knitty > Knitty, Deep Fall 2018
> Bruce The Great White Shark
Bruce The Great White Shark
For those of you too young to remember, ‘Bruce’ was the movie-set name of the mechanical shark that was used in filming the original ‘Jaws’ movie. He sank a lot.
Bruce is a knitted and felted great white shark. Once completed, he measures about 12 inches/30.5 cm long.
If made for a child, Bruce should be a room decoration only until age 3, or past the ‘everything in the mouth’ stage.
SIZE
One
FINISHED MEASUREMENTS
After felting, Bruce will be about 12 inches/30.5 cm long
MATERIALS
Yarn
Patons Classic Wool 100% wool; 210 yd per 100g skein
spacer MC Dark Grey Mix; 1 skein
spacer CC1 Aran; 1 skein
spacer CC2 Grey Mix; a few yards
Recommended needle size
always use a needle size that gives you the gauge listed below - every knitter’s gauge is unique
spacer US #9/5.5mm needles for working flat
spacer US #9/5.5mm needles for working small circumference in the round
Note: DPNs are recommended for ease of working small rounds, and for sections worked flat with small numbers of stitches.
Notions
spacer stitch holders or waste yarn
spacer a length of waste yarn
spacer stitch markers
spacer pair of 9mm brown animal safety eyes
spacer polyester stuffing
spacer yarn needle
spacer regular sewing needle, thread
GAUGE
Gauge is not critical but should be loose to allow for shrinkage during felting.
Sample gauge pre-felting was 14 sts/18 rows = 4 inches/10cm.
108448 projects
stashed 49807 times
- First published: September 2018
- Page created: September 15, 2018
- Last updated: September 18, 2018 …
- visits in the last 24 hours
- visitors right now