Craggy Shores is a beautifully textured sock pattern written for cuff down socks with instructions for a heel flap and gusset. The pattern is written for using magic loop, but if you’re a seasoned sock knitter you could easily convert it.

MATERIALS
YARN - Fingering weight approx:
400 yards {365 m}
Yardage varies widely depending on the length of your foot and the CO, but 1 skein of at least 400 yds should be plenty for a pair of socks (more than enough for a pair of shorties) for most foot sizes.

Sample uses: Six and Seven Fiber Amaranth base (100% Non-SW Merino, 436 yds/100 g) in the colorway ‘Plumage’.

NEEDLES
US 1.5 {2.5 mm} 32 - 40” {80 - 100 cm} circular needles OR a set of Neko Bamboo Flex DPN’s.
Or size needed to match your preferred gauge.

OTHER MATERIALS
Yarn Needle, Stitch Marker

GAUGE
Leg stitch pattern worked in the round & blocked.
Works with multiple gauges: 28, 32 & 36 sts per 4” {10 cm} with a round gauge close to 44 rounds per 4” {10 cm}.
---Sample got a 28 sts/44 rounds gauge and made the 54 size cast on.
---I found my stitch pattern gauge was not that far off from my stockinette gauge, maybe 1-2 sts less within a 4” {10 cm} swatch.

Use your gauge and the table on page 2 to choose the number of stitches to cast on for your size.

OTHER INFORMATION

• This pattern is broken up into 2 PDF’s, 1 for sizes: 48, 60, & 72 sts and the other for sizes: 54, 66 & 78 sts. Both are included for FREE

• There are multiple charts included in each PDF, charts for the foot, leg and heel patterns.

• This pattern has been tech edited and test knit for all sizes.

• You’ll find a coupon at the end of each PDF ;)