The NEW pattern format (V.05-NO-CHARTS) of this design with the row-by-row instructions is added. The old pattern format, compact and with charts, is also available.

In the Rockies is an asymmetrical triangular shawl that is worked on the bias, starting at the tip of the shawl with a few cast-on stitches, and finishing with a picot bind-off at the opposite side. The shaping is done with simultaneous increases at the right side and partial bind-offs at the left side of the knitted fabric, gradually increasing the total number of stitches as you progress.

The stripes of garter and stockinette stitch patterns in variegated colour alternate with the sections of a mesh stitch pattern in tonal yarn. Special attention was given to the shawl’s edge stitches that run along the side of the increases. They are worked in a cable stitch pattern using tonal colour with one stitch column of contrast colour that runs between the cable border and the shawl’s body stitches.

Finished Measurements (approx., blocked)
depth at center back x width:
one size - 32.5 x 72 inches / 82.5 x 183 cm

Gauge
20 sts x 36 rows to 4 inches / 10 cm square over garter stitch on US #4 / 3.5 mm needles, blocked, worked in fingering weight yarn.

Yardage of fingering weight yarn required (approx.)
MC: 420 yards / 384 meters
CC1: 420 yards / 384 meters
CC2: 210 yards / 192 meters

Materials
US #4 / 3.5 mm needles (24 inches / 60 cm or longer circular needles - to accommodate all the stitches), or size to obtain gauge;
tapestry needle

Recommended Yarn
MC - yarn strand in main colour, solid or tonal (light grey in this sample)
CC1 - yarn strand in contrast colour #1, variegated
CC2 - yarn strand in contrast colour #2, solid or tonal (dark blue in this sample)

Check my designer page for promotions in my store!