Print of the Wave Fingerless Mittens

My Print of the Wave fingerless mittens have been designed to compliment my Print of the Wave Beanie and both were designed for those who wished to try a lace knitting project on a smaller scale. I have used a traditional Shetland lace stitch – the ‘Print of the Wave’ on my mittens. They are knitted in the wonderfully soft ‘Lalland’ by Di Gilpin, a sportsweight yarn, and take just one 50g ball so are a really fast knit!
The Print of the Wave lace is just on the back of each mitten and the lace is mirrored on each hand so take care to use the correct chart for the correct hand!

Yarn
• 1 x 50g ball of Lalland by Di Gilpin (50g/175m) in Sea Purslane

Notions
• 1 x set of 3.5mm DPN for ribs (or preferred method for working in the round)
• 1 x set of 3.75mm DPN for body (or preferred method for working in the round)
• Tapestry needle for weaving in ends
• Waste yarn of similar weight for holding
thumb stitches
• Glove or mitten blocking boards (if you have
them)

Gauge
• 26st to 32 rows in stocking stitch measured to 10cm/4” after washing and blocking
• Please check your gauge carefully and adjust your needle size accordingly.