SEAGULLET - Beanie
The seagullet motif was inspired by a seagull that I saw in September 2019 during a trip to Shetland. The cute bird was following me while walking on Norwick beach in Unst and I took several photos of it. When back home I drew the chart and knitted a swatch, which I left in a drawer for over 3 years. Then suddenly I resumed it refining the colour combination and ta-daaaaa, a new slightly slouchy beanie was born!

YARN
Jamieson & Smith 2 ply jumper weight yarn (100% Shetland Wool; 115m / 125yds per 25g ball)
1 ball of each of the following shades:
A 3 (Pinky Fawn)
B FC58 (Marled Brown Mix)
C 1280 (Light Marled Blue Green)
D FC38 (Orange Rust Mix)
E 202 (Light Fawn)
F FC62 (Light Grey Green Mix)
G FC24 (Light Green Mix)
H FC39 (Blue Mix)

NEEDLES AND NOTIONS
Gauge-size needle(s) of your preferred type for working small circumferences
Below gauge-size needle(s) of your preferred type for working small circumferences
Stitch markers
Tapestry needle

GAUGE
28 stitches and 32 rounds to 10cm / 4in over stranded stockinette in the round on gauge-size needle(s)
Use 3.5mm needle(s) as a starting point for swatching.

SIZE
To fit adult head with 51-58.5cm / 20-23in circumference

SPECIAL TECHNIQUES
I-CORD

PATTERN NOTES
This beanie is worked from bottom to top. The brim, the body and the crown are worked in stranded colourwork.

CHART NOTES
The chart shows all the single sections of the beanie: brim, body and crown.

PLEASE NOTE: the pattern is for personal use only

Technical Editing: Frauke Urban / www.urbanyarning.com
Design, Photography and Graphics: Claudia Fiocchetti