“Feel the Force”

This amigurumi pattern creates a Star Wars inspired Yoda figure approximately 4 inches tall. The stitches should not be worked too loosely to prevent stuffing being visible through the crochet.

Any weight yarn and suitable hook may be used for this pattern, though you want to keep the gauge ratio the same so that the figure remains in proportion

Materials needed:
Green, brown and beige yarn
Safety eyes
Darning/yarn needle
Fibre fill stuffing

Abbreviations and diagrams are included in the pattern

The lightsaber seen in the photo was made from some dowel, a couple of transistor isolators and some heat shrink sleeving.

IMPORTANT
I am not supported by, or affiliated with, Disney
This pattern is for personal use only and so neither the pattern nor the product should be sold.