End of the Warp Hat
Finished
January 2015
January 19, 2015

End of the Warp Hat

Project info
plain weave with inlay
Weaving
Guild Year End Challenge
adult
Tools and equipment
SAORI WX60
Yarn
Notes

Received a 2nd place ribbon in the “Open Class” of the hand woven section of the 2015 Chilliwack Exhibition.

I created this woven (and knitted!) Saori hat using the bit of warp left over after weaving two scarves.

The selvedges of the warp were pulled to gather the edges, and then I tied the fringes from both ends together and twisted them.

I went along the front edge with a circular knitting needle picking up a stitch in each weft loop (but behind the outermost warp thread in case the weft pulled loose) and then I knitted a ribbed band.

My weaving wasn’t wide enough to fully close at the top and I had a gap, so I also picked up stitches around the hole and decreased like you would for the top of a knitted beanie.

June 20, 2016

FYI: This was leftovers from a warp for scarves. The scarves were 5.5 - 6” in width after wet finishing.

November 22, 2016

The hat and scarf were sold at the 2016 Chilliwack Christmas Craft Market.

viewed 469 times | helped 5 people
Finished
January 2015
January 19, 2015
 
  • Project created: January 19, 2015
  • Finished: January 19, 2015
  • Updated: November 23, 2016