I made this frame to fit a cork board that I wanted to use as the community events board at the shop. Attaching it to the board was simple, I used staples that are hidden by the knitting. Attaching the frame to the door was a bit more complicated due to the inset section, but if you were attaching it to a flat wall, 5/8” wire brads will work quite nicely.

Now for the changes. First, I knitted the project at a larger gauge because I was going for a larger frame and I added pattern repeats on the sides and lengthened the short sections on the top and bottom. I also used a provisional cast-on to start and grafted the end to the beginning to eliminate that horrible line in the pattern (I am a little surprised that no one else did this.)